flender reducer repair _ _ Jinan Springfield Jieyang reducer maintenance provided by the Electrical and Mechanical Equipment Co., Ltd. Jinan Springfield. Mechanical and Electrical Equipment Co., Ltd. Jinan Springfield (www.jnspray.cn) is specialized in the "Siemens Flender reducer and coupling, SKF series couplings, Germany K" of the enterprise, the company of "honesty, hard service "concept, to provide you with the highest quality products and services. Welcome to inquire! Contact: Manager Zhao. Rolling overhaul: In the reducer, the main use of rolling bearings, bearing good and bad working conditions, and a direct impact on the performance of gear reducer repair factory, life and power consumption. Rolling in the running Symptom: A, the temperature is too high. Bearing normal operating temperature of not higher than the ambient temperature 20oC, the maximum temperature is generally not allowed to exceed the ambient temperature 35oC (ambient temperature to 40oC). When the bearing housing has been hot, indicating the temperature exceeded, should open the inspection. The reason is that when the bearing causing fever dirty, oil, oily irregularities, improper assembly, overload reducer repair, bearing damage. Murmur. Noise can be checked by auscultation, poor lubrication, bearing partial damage will produce noise. 4, damage to the rolling bearing: rolling bearing fatigue spalling damage, abrasion, burns, corrosion and cracking. The reason is: irregularities grease, dirt and oil, but the gap is inappropriate, fit too tight or too loose, bearing specifications improper selection or the load is too large. Siemens workload gearhead careful to limit run-in period of maintenance standards Siemens gear reducer workload, running generally do not exceed the period Eighty-five percent rated their workload, and to arrange for the working hours, to stop deceleration occur due to prolonged continuous operation of the machine according to the overheating. Note frequently observed due to the gear reducer, if abnormal during the run-in, to promptly stop and give to exclude professional gear maintenance, not found in the cause of the fault has not ruled out before, should cease operations, businesses or manufacturers to reflect the situation, assisted solutions.